Greenhouse Working Model | Science Project

by | Jan 7, 2022 | DIY, Environment

Introduction

We’re all familiar with science projects from our school days. Every month, kids are assigned a new model. Well, did you ever get a task to make a Greenhouse working model for a science project?

The greenhouse model is one of the most interesting science models. We understand that it could appear difficult for kids to prepare, but it is actually not.

You can make your model with just a few common materials available at your house. In this post, we will tell you how you can build a Greenhouse working model in just a few hours. So give this post a quick read.

Supplies

You will need the below-written materials if you want to make this science project.

Tools

  • Hot glue gun
  • Scissors

Materials

Steps To Make Greenhouse Working Model For Science Project

If you want to make a Greenhouse working model, you just have to follow the below written steps:

Step 1: Cut out 6 strips of cardboard, 15× 1cm long

cut 6 strips

Cut 6 strips

Step 2: Cut 12 strips of cardboard with a length of 25 ×1 cm.

cut 12 strips

Cut 12 strips

Step 3: Begin assembling the strips (the bigger one) into a rectangle as shown in the picture.

Make out a rectangle from strips

Make out a rectangle from strips

Step 4: To divide the rectangle, paste one more strip in the middle.

Divide the Rectangle

Divide the Rectangle

Step 5: Start putting the strips again back together (the short ones) to form a rectangle as indicated in the figure. Add the strip to divide it.

Make another Rectangle

Make another Rectangle

Step 6: Then, as illustrated in the image, begin merging the rectangles.

Divide the Rectangle

Divide the Rectangle

Step 7: This is how it should appear.

Two Rectangles

Two Rectangles

Step 8: Cover the top with a sheet of green tracing paper.

Cover the top

Cover the top

Step 9: Cover the entire cabin in white tracing paper.

Cover the cabin

Cover the cabin

Step 10: Take two pieces of cardboard now. Begin adhering artificial plants on it.

Paste plants

Paste plants

Step 11: Apply both pieces of cardboard to the base. This is how it should appear.

Paste the two rectangles

Paste the two rectangles

Step 12: Place the hut on the base so that it covers both the plant cardboard and the base. And now you have a working model of a greenhouse.

Greenhouse

Greenhouse Working Model

Recommendations

Keep the following points in mind when you construct your model:

  • Cut the pieces into equal lengths.
  • Tracing paper should be handled with care because it is easily torn.
  • Use glue carefully so that it is neat and tidy.

So it’s your time now to give it a try. By following these simple steps, you can easily make a Greenhouse working model for science a project.

 

 

You May Also Like To Create…

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *