Introduction
Table Fans are always useful in the summer season, so in today’s article, we will teach you how to make a DIY Revolving Table Fan. Let us quickly begin.
Supplies
Let us look at the supplies required to make a DIY revolving table fan.
Tools
- Scale
- Scissors
- Masking Tape
- Cutter
- Spray Paint
- Hand Saw
Materials
- Pencils or Sketch Pens
- Plastic Bottle
- 12 V DC Gear Motor
- 12 V DC Motor
- Copper Wire
- Joystick Switch
- Batteries
- Iron Rod
- Paper
- Clay
- Two Servo Motors
Steps To Make A DIY Revolving Table Fan
Step 1: The first step is to cover the bottleneck with the help of Masking tape.
Covering the Bottle Neck with Tape
Step 2: Now, remove the masking tape and do the markings on them.
Removing and doing Markings
Step 3: Measure and cut 33 cm of the masking tape and then place it on the bottle.
Measuring and Placing the Tape on the Bottle
Step 4: Trace a triangular shape from the edges of the tape to the bottleneck. Once again, repeat this step on the other side.
Tracing the Triangles
Step 5: The next step is to cut the top section of the bottle.
Cutting the Top section of the Bottle
Step 6: Take a paper and cut it in the following manner.
Cutting the Paper
Step 7: The next step is to trace the design on all sides of the bottle head.
Tracing the Design
Step 8: Cut the bottle and make it into a fan. While cutting the cut, the fan also cut the head on the bottle.
Making Fan
Step 9: Apply a coat of paint to the fan.
Applying Paint on Blades
Step 10: Take the servo motor to apply some clay on its pointed shaft and fix it with the fan.
Fixing the Motor
Step 11: Cut the lower side of the sketch pen with the hand saw.
Cutting the Sketch Pen
Step 12: Stick the trimmed lower sketch pen section on the servo motor in the following manner.
Fixing the Sketch Pen
Step 13: Simultaneously, connect another trimmed sketch pen to another servo motor.
Connecting the Trimmed Sketch Pen
Step 14: Take a wooden board and spray a coat of paint on it.
Painting the Wooden Board
Step 15: Take some pencils and stick them together. Once they are attached, stick them on the wooden base as a pillar.
Making a Pillar
Step 16: Simultaneously, repeat this step, make a smaller stand and stick it next to the big stand. Once you stick them gently, fix all the apparatus over them.
Making a Small Stand and fixing the Apparatus
Step 17: Now, take a small copper rod and it with two ends.
Connecting the Two Ends with Copper Rod
Step 18: Collect some iron rods and stick them closely on a circular sheet.
Arranging Iron Rods in Circular Manner
Step 19: Bend the iron rods and make them like a fan shape.
Making a Fan
Step 20: Gently fix the blades inside the cover.
Fixing the Blades in the Fan
Step 21: Connect the wires with the battery and joystick switch.
Connections
Step 22: The last step is to turn on the power source and joystick switch
DIY Revolving Tabel Fan
Recommendation
- You can colour the pain according to your imagination.
Things To Remember
- Make sure you appropriately connect all the connections.

Saquib Siddiqui is a Mechanical Engineer with expertise in science projects and experiments. Saquib’s work focuses on integrating scientific concepts with practical applications, making complex ideas accessible and exciting for learners of all ages. In addition to his practical work, Saquib has authored several articles, research papers, and educational materials.
0 Comments