Introduction
Hydraulic Jack is used to lift all types of loads. It is one of the good ideas for a Science Project. So, in the following article, we will discuss how to make a hydraulic jack. Our main aim is to make a cost-efficient and reliable hydraulic jack.
Supplies
It is always suggested to be prepared with supplies before preparing the hydraulic jack. So, let us look at it. They are as follows:
Materials
- Sixteen Strong Cardboard
- Medical Pipe
- Medical Pipe Connector
- Bamboo Sticks or Sausage Sticks
- Two Syringes
- Cardboard
Tools
- Glue
- Sharp Knife
- Metal Scale
- Needle
- Scissors
Steps To Make Hydraulic Jack For Science Project
Step 1: The initial step is to start dividing each cardboard into three points.
Dividing the Cardboard
Step 2: Use a needle to make holes at these points, and with the help of sausage sticks, make these holes bigger.
Making the Holes with needles and Sausage Sticks
Step 3: Take scissors or knives and cut the edges.
Cutting the Edges
Step 4: The next step is to arrange the cardboards in a criss-cross manner and pass the bamboo sticks.
Arranging Cardboards
Step 5: Use the hot glue to close all the ends of the sticks and repeat this same process for another end also.
Sticking the ends
Step 6: Place the cardboard, which will be the base for the project.
Placing the Cardboard
Step 7: Stick the front two ends of the chain on the cardboard
Sticking the Front Two Ends
Step 8: Stick the pressing end of the syringe to the chain.
Sticking the Syringe End
Step 9: Place the remaining cardboard piece over the jack and then use the medical pipe to connect with another syringe.
Connecting with Another Syringe
Hydraulic Jack
Things To Remember
- Make sure you fix all the connections appropriately.
Saquib Siddiqui is a Mechanical Engineer and a content creator. He has special interest in science experiments and teaches the same to school and college students. He is also a technical lead at RUDE LABS PVT. LTD.
0 Comments