How To Make A LEGO Cable Holder

by | Apr 19, 2022 | DIY, LEGO

Introduction

In the previous article, we learned how to make a Lego desk organizer, which has helped you manage your desk. Today, we will teach you how to make a Lego Cable Holder, which will help you manage the charging cables. Let us begin.

Supplies

In the second section of the article, let us note the list of essential supplies to make a Lego Cable Holder. They are as follows:

Materials

  • Lego Minifigures
  • Clay

Steps To Make A LEGO Cable Holder

Step 1: The first step is to take one sugru and then gently knead it for a couple of seconds. Once you are done, slowly roll the sugru and inside the little sausage.

Minifigure and Sugru held next to each other

Fixing the Sugru in the Sausage

Step 2: The second step is to gently press the sugru on the back of your clay.

Sugru being applied to back of Minifigure

Fixing the Clay

Step 3: The third step is to shape the sugru in the shape of a cone. For this step firstly gently press the sugru from the sides and then start shaping it from the top side.

Sugru shaped into cone

Shaping the Sugru

Step 4: In the following step, you have to choose a surface where you want to place the sugru. Once you decide the appropriate space or surface, gently fix the sugru on it.

Minigifure pressed against table with Sugru

Selecting the Surface

Step 5: Once you place the sugru on the surface, apply a strong force and fix it.

Sugru used to stick minifigure to desk

Placing the Sugru

Step 6: The last step is to take the wire and make it hold with the sugru

Different minifigures stuck down with Sugru holding wires

Attaching the Cable

Recommendation

  • We recommend you to leave the sugru for twelve to fourteen hours to get set.

Things To Remember

  • Make sure you strongly fix the sugru
  • Ensure you do not leave any space or gaps between the sugru and the edges.

 

You May Also Like To Create…

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *