Rotating DNA Model | Science Project

by | Jan 9, 2022 | Biology, Science

Home » DIY » Rotating DNA Model | Science Project

Introduction

You must have projects to complete in schools, and science assignments are always the most enjoyable. So you want to get the best grades and be the best student in your class? It’s all up to you. This is a fantastic tutorial for creating a rotating DNA model for a science project. Continue reading to find out more.

Supplies

If you have all of the necessary components on hand, making a revolving DNA model is a breeze. So, if you want to create a rotating DNA Model at home for a scientific project, you’ll need the following materials:

Tools

  • Soldering Rod
  • Hot Glue Gun
  • Scissors/Cutter

Materials

  • Cardboard
  • Color Paper
  • Paper Straw
  • Plastic Straws
  • Colorful Beads
  • Gear Motor
  • Battery
  • Button

Steps To Make A Rotating DNA Model For Science Project

Given that you have the materials list let’s just get going on building a rotating DNA model. If you follow the directions, creating your rotating DNA model will be a breeze:

Step 1: Take a cardboard piece of size 27×15 cm and cover it with a green color sheet.

Cut out cardboard

Cut out cardboard

Step 2: Now, take a paper pipe and attach plastic straws to it, as shown in the image.

Paste the straws

Paste the straws

Step 3: Make small cuts at the outer end of the plastic straws and insert colorful beads onto them with the help of a glue gun.

Insert the beads

Insert the beads

Insert the beads

Step 4: Then, take a gear motor and attach a wire to it with the help of a soldering rod. Connect the other end of the wire to a battery holder.

Attach the wire

Attach the wire

Attach the wire

Step 5: Stick double tape at the bottom of both pieces and attach it to the cardboard base.

Stick it on the base

Stick it on the base

Stick it on the base

Step 6: Now, put a round button-like thing with a hole in the middle and attach it to the rotating part of the motor with the help of a hot glue gun.

Join the rotator

Join the rotator

Join the rotator

Step 7: Cut the appropriate size of cardboard to cover the motor attached and paste it onto the base.

cover the motor

Cover the motor

Step 8: Make a hole at the top covering piece and pass it through the previously prepared DNA set. Secure it to the rotating end with the help of the hot glue gun.

Attach the DNA piece

Attach the DNA piece

Attach the DNA piece

Attach the DNA piece

Step 9: Attach any AA or AAA battery to the battery holder. Your Rotating DNA model is ready to go.

Rotating DNA Model

Rotating DNA Model

Recommendations

  • Be attentive with electric equipment: Keep your eyes open while handling the hot glue gun and the soldering rod as slight carelessness can cause harm to you.

Now you’re free to attempt it on your own. It’s now up to you to be inventive and earn top marks on your science projects. These simple instructions will guide you on how to create a rotating DNA model for a science project. So have a look at the instructions and give it a shot.

 

 

You May Also Like To Create…

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *